CF MOTO CF500-5, Service Manual

Page: 144 / 254

6-44
CFMOTO
Bevel gear
Bevel gear backlash
I
nstall drive and driven gears to the
crankcase. Wrap a (-) screwdriver 3with a rag
2 and insert it into the speed sensor hole 1 of
left crankcase to fix the drive bevel gear.
Adjustment:
Measuredbacklash Washer thickness
adjustment
<0.1mm Decrease washer
thickness
>
0.2mm Increase washer
thickness
0.1~0.2mm Correct
Install special tool3 and
micrimeter 4
Tool:Bevel gear side clearance
dial gauge micrometer
a=46mm
Turn the driven bevel gear in each direc-
tion and measure the backlash
.
NOTE: Measure four points in the mutual ver-
tical direction
If the backlash is not within the specification,
adjust the thickness of the driven bevel gear
adjust washer. Re-check the backlash until the
backlash is correct
Bevel gear backlash:0.1-0.2mm
Note: Proper bevel gear engagement de-
pends on that the gear backlash and tooth
contact are within the proper range.