CF MOTO CF500-5, Service Manual

Page: 228 / 254

12-6
CFMOTO
Pickup Coil
Note:
Measure after all the wires are correctly
connected.
Inspect with compression pressure in the
cylinder, spark plug and spark plug cap are prop-
erly installed. If the spark plug is removed and
then do the measurement, the peak voltage will
rise.
Remove left side panel.(2-8)
Remove front cover(2-2)
Disconnect CDI unit connector.
Connect peak voltage oscillograph terminal with the
following terminal of main cable.
Special Tool:
Peak Voltage Oscillograph 07HGJ£-0020100
(Use together with digital multimeter available
from the market with input impedance over
Connecting terminal: blue/yellow(-)-green(+)
Turn ignition switch to the ON position, and start
engine.
Peak Voltage: Over 2V
Note:
When measuring the voltage, do not touch the
terminal with finger to avoid electric shock.
If peak voltage obtained from CDI unit connector
is improper, measure again the peak voltage on
the AC magneto 2P connector.