CF MOTO CF500-5, Service Manual

Page: 183 / 254

8-6
CFMOTO
Disassemble
remove foot rest(2-9)
remove front inner fender RH(2-12)
remove bolt1, bolt2
seperate pedal brake master cylinder from the body
Assembling
Assembling carry on according to the opposite se-
quence of disassemble.
Attention
To avoid air inlet the brake pump, thus you must
to keep the assemble position, at the same time,
fix it in the vehicle body.
Oil tube trend refers to Section1 cable, wire traces.
It must ensure the brake oil line smooth. After
complete the brake system installation, check-
ing the brake effort is required.
Brake Y-joint
Disassembling
remove front inner fender RH(2-12)
remove bolt 1 then the brake Y-joint canbe remove
form the body.
Assembling
Assembling carry on to the opposite sequence of
disassembling.
Attention:Oil tube trend refers to section 1, cable
and wire traces, the brake oil line must be smooth.
Brake force checking is required when complete
the brake system installation. If it cannot gang
control the brake system, check if the stem T-
junction, brake force checking is required after
finish the brake system installation.
Brake cross joint plug
Disassembling
remove front inner fender RH(2-12)
remove bolt 1, bolt 2, then the cross joint plug canbe
remove from the body.