CF MOTO CF500-5, Service Manual

Page: 142 / 254

6-42
CFMOTO
Oil strainer inspection
Check oil strainer1 and O-ring 2
for damage. Replace if necessary;
Clean the surface of oil strainer
with engine oil;
Relieft valve
Check the valve body1,valve2,srping3 and
0-ring4 for damage or wear;
Drive bevel gear
Use a clean rag to protect the drive bevel
gear shaft, clamp it to the pliers;
1-Drive bevel gear cover 5-Washer
2-Output driven gear 6-Drive bevel
gear shaft
3-Drive bevel gear nut 7. Bearing nut
4-Drive bevel gear 8. Bearing
8
Drive bevel gear nut
tightening torque:145N.m
Loosen drive bevel gear nut 3,
remove the drive bevel gear 4 and
adjust washer 5
Check the drive bevel gear 4 and output
driven gear 2 for rust, scratch, wear or
damage. Replace if necessary.
Check if the bearing 8 turns smoothly, re-
place with a new bearing if necessary.
Adjust Washer 5 if any of right crankcase,
drive bevel gear 4, or drive bevel gear
cover 1 is replaced. Refer to bevel gear
adjustment for details.
Apply engine oil to bearing 8 when as-
sembling and tighten nut 3 to the speci-
fied torque.