CF MOTO CF500-5, Service Manual

Page: 232 / 254

12-10
CFMOTO
Starter Relay
Apply 12V to the terminals and check for continuity
between positive and negative terminals using
multimeter.
If starter relay clicks and continuity is found, the starter
relay is OK.
If there is no continuity without 12V voltage, the starter
relay is OK.
Note:
Do not apply the battery vboltage to the starter relay
for more than 2 seconds. This may cause overheat and
damage the relay coil.
¡ñMeasure resistance between coils of starter relay
using multimeter. Replace the starter relay with a new
one if the resistance is not within the specified value.
Set multimeter to position.
Starter Relay Coil Resistance:
Auxiliary Starter Relay
Apply 12V voltage to the positive and negative termi-
nals of starter relay coil and check for continuity be-
tween A and B using multimeter.
If starter relay clicks and continuity is found, the starter
relay is OK.
If there is no continuity without 12V voltage, the starter
relay is OK.
Set multimeter to position.
A u x i l i a r y S t a r t e r R e l a y C o i l R e s i s t a n c e :