CF MOTO CF500-5, Service Manual

Page: 219 / 254

11-6
CFMOTO
Remove fuse box from inside of rear fender.
t amperemeter between battery negative pole
and negative lead
Measure current leakage with ignition switch at the
“OFF” position.
Note:
z
If the measured current is higher than the maximum
limit, the multimeter will be burnt. Therefore, measure
the current by shifting from the high to the low range.
z
Do not turn on the ignition switch when measuring
the current.
Current Leakage: less than 1mA
When current leakage is higher than specified limit,
there is fault with the return circuit.
Disconnect terminals and connectors while
measuring current to check out the faults.
Rectifier/Regulator
System inspection
Note:
Inspection can be done without removing the AC
magneto from engine.
Remove:
Seat
Battery cover and battery
(11-4)
Disconnect the 2 connectors of rectifier/
Regulator