CF MOTO CF500-5, Service Manual

Page: 147 / 254

6-47
6 Engine Removal, Inspection & Installation
6 6
6 6
6
Check starter clutch roller and holder for
abnormal wear or damage,replace if
necessary.
Replace the starter clutch in the right
direction.
Note:
When install the starter clutch to
the magneto rotor, make sure side
A is in the right direction.
Face arrow mark B to the engine side;
Apply thread locker to bolt and
tighten to the specified torque.
Install the starter driven gear.
Tightening torque of starter clutch bolt: 26N.
m. Material: Thread locker
Make that the starter driven gear turns in the
opposite direction of the arrow mark B The
gear cannot turn in the direction of the arrow.
Check starter driven gear bearing. In case
of anything unusual, replace the bearing.
Remove starter driven gear bearing with
special tool
.
Install starter driven gear bearing with spe-
cial tool.
Tool:Bearing installer/Remover
Apply engine oil to starter clutch;