CF MOTO CF500-5, Service Manual

Page: 217 / 254

11-4
CFMOTO
Battery
Note:
Keep the ignition switch at OFF before operation.
Remove:
—Seat (-2-3)
—Bolt1&Bolt2
—Battery fixing plate
—Battery cover
Loosen negative pole screw and
disconnect negative lead.
Remove positive pole cap and screw.
Disconnect positive lead.
Installation:
Reverse the removal procedure for installation.
Note:
Apply clean lubricant grease to the
pole after installation.
Install cap firmly on the positive pole
after installation.
Inspection:
Measure voltage between battery terminals, and
check test status.
Complete test: 12.8V
Insufficient test: <11.8V
Insufficient charge: --- Recharge
Note:
When recharging after normal charging,
measure the voltage between terminals
after 30 minutes. Measuring immediately
after recharging will not gain the correct
test due to the sharp voltage changes
between the terminals.
Battery
Note:
Usually no hydrogen will be generated during
charging except when overcharged.
Keep away from fires when charging.
Charge according to the current and time
specified on the label of battery.
Remove battery from vehicle. (Refer to above content)