Blackmagicdesign Teranex 2D Processor, Installation And Operation Manual

Page: 40 / 969

Quad SDI Output Menu for Teranex AV only
Teranex AV provides continuous quad SDI outputs via four dedicated BNC connectors when
Ultra HD output formats are in use. The BNC output connectors are labeled ‘ch A’, ‘ch B’, ‘ch C’,
and ‘ch D’.
Teranex AV supports ‘quad link’ two-sample interleave, or 2SI, and ‘quad HD split’ square
division outputs for Ultra HD p50/59.94/60 output formats. Use the ‘quad SDI output’ menu
below to define the output type you are using.
For Ultra HD p23.98/24/25/29.97/30 formats, only ‘quad HD split” is supported, regardless of
the setting in the ‘quad SDI output’ menu.
Video>Setup>Quad SDI Output
This diagram represents the difference between ‘quad link’, where image information is split
between four 3G-SDI cables to form a single Ultra HD image, and ‘quad HD split’, where each of
the four HD outputs receives one quarter of the complete image.
Proc Amp Menu
Use the ‘proc amp’ menu to adjust gain, saturation, hue, sharpness and more. The ‘proc amp’
menu is accessed via the ‘video’ menu. A quicker way to reach this menu is by pressing one of
the ‘proc amp’ video buttons on the control panel. Turn the rotary knob to adjust your settings.
TIP This setting only applies when outputting 3G-SDI video. For 3G-SDI inputs, ‘level A’
and ‘level B’ signals are detected automatically.
Quad Link
Quad HD Split
Setup
SDI
Output
3G SDI
Output
No Video
Input
Quad SDI
Output
OPTICAL
OUT/IN
SD/HD/3G/6G/12G-SDI
OUT A OUT B CH C CH D
CH A CH B
HDMI OUT
QUAD 3G-SDI OUT
PUSH
OPTICAL
OUT/IN LOOP A IN B IN A
SD/HD/3G/6G/12G-SDI
STEREO IN CH 2
LOOP B OUT A OUT B CH C CH D
CH A CH B
L
R
HDMI IN HDMI LOOP HDMI OUT
QUAD 3G-SDI OUT AUDIO IN
Quad Link Quad HD Split
40 40 Teranex Processor Settings