Blackmagicdesign Teranex 2D Processor, Installation And Operation Manual

Page: 50 / 969

In Teranex 3D, Dolby metadata may be derived from incoming Dolby audio, if a Dolby decoder
is installed, and may also be input as serial data via the 9-pin Dolby metadata connector on the
rear of the Teranex 3D. You may also generate your own metadata in the Teranex 3D by using
one of the two commonly used configurations provided in the ‘dolby metadata’ menu, ‘stereo’
and ‘5.1’. See the configurations assigned by each in the table below. The variations between
the two configurations are shown by bold text.
The ‘dolby metadata’ menu provides for:
‚
Pass-Thru
If your Teranex 3D also contains a ‘dolby decoder’ module, any metadata derived from
the decoded Dolby stream will be reinserted in the Dolby encoded output.
‚
External
To add metadata from an external metadata generator to your Dolby encoded output,
connect the generator to the ‘9 pin dolby metdata’ connector on the rear panel.
‚
Stereo
Pre-configured metadata for stereo output.
‚
5.1
Pre-configured metadata for 5.1 encoding, typically used with Dolby digital encoding.
Metadata Parameter Stereo 5.1
Program Configuration 4x2 5.1+2
Program Description Text Not programmed Not programmed
Frame Rate Set by Conversion Set by Conversion
Bitstream Mode Complete Main Complete Main
Channel Mode 2/0 L/R 3/2 L,C,R,Ls,Rs
Center Downmix Level -3 dB -3 dB
Surround Downmix Level -3 dB -3 dB
Dolby Surround Mode Not Indicated Not Indicated
LFE Channel LFE Off LFE On
Dialogue Normalization 27 27
Audio Production Information No No
Mix Level 0 0
Room Type Not Indicated Not Indicated
Copyright Bit Yes Yes
Audio
System
Setup
Output
Options
Ancillary
Data
Noise
Reduction
Video Main Menu
Main Menu>Audio Audio Menu>Dolby Metadata
Audio
Output
Mapping
Audio
Gain
Dolby
Metadata
Dolby
Encode
Audio
Delay
Setup
Dolby Metadata Menu
Dolby Metadata
Stereo
External
5.1
Pass-Thru
Dolby
Metadata
50 50 Teranex Processor Settings