Biotek Synergy H1, Operator'S Manual

Page: 83 / 190

Clean Exposed Surfaces
Exposed surfaces may be cleaned (not decontaminated) with a cloth moistened (not
soaked) with water or water and a mild detergent.
You will need:
l
Deionized or distilled water
l
Clean, lint-free cotton cloths or paper towels
l
Mild detergent (optional)
Procedure:
1. Important! Turn off and unplug the instrument.
2. Wet a cloth or paper towel with water, or with water and mild detergent, and then
thoroughly wring it out so that liquid does not drip from it .
3. Wipe the plate carrier and all exposed surfaces of the instrument.
4. Wipe all exposed surfaces of the dispense module (if used).
5. Wipe all exposed surfaces of the gas controller module (if used).
6. If detergent was used, wipe all surfaces with a cloth moistened (not soaked) with
water.
7. Use a clean, dry cloth to dry all wet surfaces.
Models with injectors: If the tip priming trough overflows or other spills occur inside
the instrument, wipe the carrier and the surface beneath the carrier with a dry cotton
cloth. The internal chamber and probes are not customer-accessible. If overflow is
significant, contact BioTek’s Technical Assistance Center.
Synergy H1 Operator's Manual
Clean Exposed Surfaces | 57