Biotek Synergy H1, Operator'S Manual

Page: 51 / 190

Prepare the Dispense Module for Shipment
Refer to the illustrations on the next two pages when performing these steps.
1. If you have not already done so, contact BioTek’s Technical Assistance Center for a
Service Call Notice (SCN) number and the shipping address before returning
equipment for service.
2. Decontaminate the module according to the instructions starting on page 66 . Be sure
to purge the dispense module of all fluid when finished.
3. With the reader on, start Gen5 and select System > Instrument Control >
Synergy H1 .
4. Perform this step twice, once per dispenser: Click the Prime tab (or Dispenser tab,
if using Gen5 v2.05 or lower) and set the number (1 or 2). Click Maintenance . The
syringe bracket lowers. Remove the thumbscrew from underneath the bracket.
Carefully unscrew the top of the syringe from the syringe valve. Lift out the syringe
and store it in its original box.
5. Fully detach the dispense module from the reader. Set the module aside for the
moment.
6. Remove the tip priming trough and store it in the dispenser accessories bag.
7. Remove the two inlet tubes from the syringe valves and store them in their plastic
canisters.
8. Remove the two outlet tubes from the syringe valves. Attach the clear plastic
shrouds to the fittings of the outlet tubes. Place the tubes in a plastic bag.
9. Remove the front cover from the dispenser.
10. Insert the bottom foam end cap in the dispenser module accessories shipping box
and place the accessories in the insert.
11. Insert the bottom foam end cap in the shipping box, and place the dispense module
inside the end cap.
12. Insert the foam insert that holds the reagent bottle holders and injector tubing into
the shipping box and place the bottle holders and tubing in it.
13. Slide the dispenser accessories box into the shipping box.
14. Insert the top foam end cap. Close and seal the outer box with tape.
15. Write the SCN number on the outside of the box. Ship the box to BioTek.
Synergy H1 Operator's Manual
Repackaging and Shipping Instructions | 25