Beckman Coulter Navios, Instructions For Use Manual

Page: 510 / 586

773232AH
13-18
Troubleshooting
Cytometer Messages Table
Data Socket Error A data communication error has
occurred between the workstation
and the instrument. Check the Ethernet cable between the
workstation and the instrument. Restart the
entire system. If the error persists, contact
your local Beckman Coulter Representative.
Detector X Incorrect Type The type of detector X does not
agree with the type in the instrument
configuration. Restart the entire system. If error persists,
contact your local Beckman Coulter
Representative.
Detector X Missing The instrument is configured for
detector X but no detector could be
found. Restart the entire system. If error persists,
contact your local Beckman Coulter
Representative.
Drip Chamber Level Error The drip chamber is full and the
acquisition has been aborted.
Results displayed on the workspace
are incomplete. To avoid the error in the future, change the
sample concentration or protocol stop
condition to reduce the acquisition time to
be 18 minutes or less.
If the recommended action has been taken
and the error persists, contact your local
Beckman Coulter Representative.
Drip Chamber Level Warning When this message is displayed
during acquisition there is enough
spare volume for another three
minutes of sample analysis. Stop the acquisition in a controlled way. To
avoid the message in the future, change the
sample concentration or protocol stop
condition to reduce the acquisition time to
18 minutes or less.
If the recommended action has been taken
and the warning persists, see
Drip Chamber
Level Error
.
Drip Or Waste Overfill Error The drip or waste chamber has
overflowed and the acquisition has
been stopped. contact your local Beckman Coulter
Representative.
Event Checksum Failures The checksum of an event passed
from the instrument to the
workstation is incorrect. Restart the entire system. If error persists,
contact your local Beckman Coulter
Representative.
Failed to Power Off The instrument failed to turn off. Power The Cytometer Only On/off . If error
persists,contact your local Beckman Coulter
Representative.
Fluidics Board Not Found The fluidics I/O board could not be
detected. Restart the entire system. If error persists,
contact your local Beckman Coulter
Representative.
Fluidics I/O Board Voltage Error The voltages on the fluidics I/O board
are out of range. Restart the entire system. If error persists,
contact your local Beckman Coulter
Representative.
Front Panel Connection Fault – SCA1 A fault was detected in the
connection between the data
acquisition board SCA 1 and the front
panel display board. Restart the entire system. If error persists,
contact your local Beckman Coulter
Representative.
Table 13.2
Cytometer Messages
(Continued)
Message Probable Cause Recommended Action