Beckman Coulter Navios, Instructions For Use Manual

Page: 512 / 586

773232AH
13-20
Troubleshooting
Cytometer Messages Table
Optics Temperature Stabilizing The temperature of the optics is
stabilizing. If the optics temperature does not stabilize
within a reasonable time then restart the
entire system. If the problem persists then
contact your local Beckman Coulter
Representative.
Optics Temperature Warning The temperature of the optics differs
considerably from the temperature
when the optics were aligned such
that the instrument may not meet its
specification. Wait till the temperature of the optics is
closer to that when the instrument was
aligned or realign the optics for different
ambient temperature range.
Overflow Error The drip or waste container has
overflowed and the acquistion has
been stopped. Contact your local Beckman Coulter
Representative.
Pico Motor Board Not Found The pico motor control board could
not be detected. Restart the entire system. If error persists,
contact your local Beckman Coulter
Representative.
Place tube in position 21 Single Tube Fixed Mode selected Place tube in position 21 and select Run to
continue in this mode.
To discontinue operation in this mode,
depress the Single Tube Fixed Mode button
on the Cytometer Control toolbar.
Pressures Not Calibrated Pressures can not be calibrated
because pressure control board can
not be detected or calibration
coefficients corrupted. Restart the entire system. If error persists,
contact your local Beckman Coulter
Representative.
Probe Up/Down Error The probe failed to move up or down
correctly after several attempts. Restart the entire system. If error persists,
contact your local Beckman Coulter
Representative.
Probe Up/Down Warning The first attempt to raise or lower the
probe failed. None. The instrument will automatically
retry to raise or lower the probe. If warning
persists, contact your local Beckman
Coulter Representative.
Red Laser Comms Warning Unable to communicate with red
laser. Restart the entire system. If the error
persists, contact your local Beckman
Coulter Representative.
Red Laser Fault A fault occurred on the red laser
during acquisition and the
acquisition was stopped. Restart the entire system. If the error
persists, contact your local Beckman
Coulter Representative.
Red Laser Fault Warning There is a fault condition on the red
laser. Check optics covers are properly installed
and tightened. See Red Laser Fault.
Red Laser Initialization Error The red laser failed to initialize. Restart the entire system. If the error
persists, contact your local Beckman
Coulter Representative.
Table 13.2
Cytometer Messages
(Continued)
Message Probable Cause Recommended Action