64
ImagePRO-II • User’s Guide
4. Menu Orientation
Acquiring an Input Signal
The first three options on this menu support setting up the test pattern in the
default active area and creating an optional raster box around it. The fourth
choice,
AOI Raster Box
, lets you display a raster around the Area of Interest,
when that area differs from the default active area.
2.
To turn on a test pattern, select
Type
. The choices for this option are:
~
Off (default)
Burst
~
H Ramp
50% Gray
~
V Ramp
Gray Steps 1
~
100% Color Bars
Gray Steps 2
~
75% Color Bars
White
~
16x16 Grid
Black
~
32x32 Grid
SMPTE Bars
3.
Scroll through the list to find the pattern you want, then press
SEL
.
4. Raster
Box
turns on a raster around the default active area. This raster box is a
white, single-pixel-wide broken line.
Raster Box
is either
On
or
Off
.
5.
Turn
Diag Motion
on or off to create motion for select patterns.
~
The motion is a
bottom-right to top-left diagonal
for 16x16 Grid, 32x32
Grid, Burst, 75% Color Bars, and Gray Steps 1.
~
The motion is
right to left
for 100% Color Bars.
~
The motion is
bottom to top
for Gray Steps 2.
~
There is
no motion
in H Ramp, V Ramp, or Black patterns.
~
The motion is a
strobing effect
for White and 50% Gray.
6.
If your Area of Interest is smaller than the output active area, you can select
AOI
Raster Box
to create a raster around the AOI. This raster is a green, 1-pixel-wide
broken line that helps you to position the AOI within the output’s active area.
Out
Raster Box
is either
On
or
Off
.
^ÅèìáêáåÖ=~å=fåéìí=páÖå~ä
The ImagePRO-II
uses the
In Auto Acquire
function on the
Setup Menu
to acquire the
input signal automatically.
In Auto Acquire
can be either
On
or
Off
. The default setting is
On
.
When
In Auto Acquire
is
On
, the system performs a full sync acquisition on the input
signal whenever:
•
You select an input
•
The input type changes
•
The sync rate of the input signal changes
During acquisition, the system detects and acquires the input type and resolution. Menu
selections are limited to those applicable to the detected type.
When
In Auto Acquire
is off, the system uses the last known configuration for each input,
when possible. If the input signal is incompatible with the saved configuration, a good input
lock may not be possible. In this case, the format name field in the
Status Menu
displays
Summary of Contents for ImagePRO-II
