ImagePRO-II • User’s Guide
21
3. Hardware Installation
Installation
d.
Connect the video source(s) to the analog or digital input connectors as
required.
7. Output
Connections
e.
To connect the ImagePRO-II to a digital projector or other digital display,
connect one of the following output connectors to the appropriate input
of
the display device:
•
DVI-D
•
HDMI
•
DisplayPort
•
SDI-1
f.
To connect the ImagePRO-II to an analog display, connect the
ImagePRO-II’s analog output to the analog input of the display device.
8. Genlock
Connections
g.
If you will be using synchronous video camera sources in your
production, use a BNC cable to connect a PAL or NTSC black burst or an
HD tri-level sync signal to the
Genlock In
connector.
h.
If you are looping reference video to another unit in your system, connect
a BNC cable from the
Genlock Loop
connector to the next device’s
Genlock In
connector.
i.
If this ImagePRO-II unit is the last device in a reference video chain,
terminate the
Genlock Loop
with a 75
termination.
9. Power
Connection
— Connect an AC power cord to the
AC Power Connector
on the rear of the ImagePRO-II chassis, and then to AC outlets. Connect AC
power cords (or AC adapters) to all peripheral equipment, such as Ethernet
switches and monitors. Please note:
~
Connect each unit only to a properly rated supply circuit.
~
Reliable grounding (earthing) of rack-mounted equipment should be
maintained.
10. Power On
— Turn on power to all units.
11. Web Interface Connection
To configure your system for control from the ImagePRO-II’s Web Interface, refer
to Chapter 5,
Web Remote Control Operations
, on page 99. Following are
prerequisites for remote web operations:
j.
Ensure that your computer uses one of the following operating systems:
•
Windows
®
XP, Windows Vista™, or Windows 7
•
Mac OS
®
X
•
Red Hat
®
Linux
®
k.
Ensure that you have an
HTML5-compatible web browser
installed,
such as Google Chrome, Apple Safari
®
or another browser based on the
WebKit engine. Or download
Google Chrome Frame
to work with
Internet Explorer.
l.
Turn on the ImagePRO-II’s
DHCP
setting:
•
On the
Setup Menu
, select
System
>
Ethernet
.
•
Select
DHCP
and turn it
On
.
m.
Verify the IP address of the ImagePRO-II. (Refer to Chapter 4, the
section titled
Setting Ethernet Options
on page 83.)
Summary of Contents for ImagePRO-II
