ImagePRO-II • User’s Guide
81
4. Menu Orientation
Using the System Menu
The following illustration shows the
USB Backup/Restore Submenu
, which you access
from the
System Menu
.
Figure 4-67.
USB Submenu
Using this menu, you can:
•
Detect the presence of a USB device.
•
Back up and restore ImagePRO-II configuration files. When you connect a flash
drive to the ImagePRO-II, the ImagePRO-II creates a directory titled
ImagePRO2Backup
on the drive. All logo images and configuration files are
saved to this directory.
•
Download and restore a logo image from another ImagePRO-II.
_~ÅâáåÖ=ré=`çåÑáÖìê~íáçå=cáäÉë
To back up a configuration file to a flash drive, use the following procedure:
1.
Insert a formatted flash drive in the ImagePRO-II’s front-panel USB port.
2.
From the
System Menu
, scroll to the
USB Backup/Restore Submenu
. Select
Backup Config
.
The
USB Backup Config Submenu
appears, as shown in the following
illustration. The navigation cursor appears at the default name for the first backup
file.
Figure 4-68.
USB Backup Config Submenu
3.
If you wish to change the default name of the backup configuration, press
SEL
.
Use the
ADJUST
knob to change the name, as described in
Saving an Input
Configuration
on page 45. Press
SEL
again when you complete the name
change.
4.
Scroll to
Backup Config
and press
SEL
.
A confirmation message appears when the backup is complete.
If the backup operation fails, the message shown in the following illustration
appears. Check that the flash drive is properly formatted and installed, and try
again.
USB BACKUP/RESTORE
> USB Detected
No
Backup Config
>>
Restore Config
>>
Backup Logo
>>
Restore Logo
>>
U S B B A C K U P C O N FIG
> S ysB acku p1
B ackup C onfig
(FA T filesystem only)
Summary of Contents for ImagePRO-II
