88
ImagePRO-II • User’s Guide
4. Menu Orientation
Using the System Menu
Figure 4-79.
EDID Confirmation Message
pÉííáåÖ=aáëéä~ó=_êáÖÜíåÉëë
The
VFD Brightness Submenu
adjust the intensity of the front panel vacuum fluorescent
display (VFD) screen. The adjustment range is
+0
to
+6
, with
+6
being the brightest. The
default setting is
+3
.
içÅâáåÖ=íÜÉ=cêçåí=m~åÉä
When the ImagePRO-II’s front panel is locked, button presses have no effect. In the locked
mode:
•
All button presses and all turns of the
ADJUST
knob are ignored.
•
All Ethernet and serial communications commands function normally.
•
All button lights continue to reflect the correct state of the inputs.
To enable and disable the front-panel lock, use the following procedure:
1.
On the
System Menu
, scroll to
Lock Front Panel
and press
SEL
.
The front panel is locked, and the following message appears.
Figure 4-80.
Front Panel Locked Message
2.
To disable the front panel lock, press and hold the
SEL
and
ESC
buttons
simultaneously for 3 seconds. When the panel is unlocked, the display screen
displays the
Status Menu
.
EDID Prog Done
<ESC> = Continue
Note
Using a low intensity is advisable, to avoid “burn-in” of the
display screen.
Front Panel
Locked Out.
Unit ID 18
Summary of Contents for ImagePRO-II
