20
ImagePRO-II • User’s Guide
3. Hardware Installation
Installation
Chapter 4, or by using zoom and pan settings, as described in
Creating a View
on page 71 in Chapter 4.
fåëí~ää~íáçå=oÉèìáêÉãÉåíë
To set up the ImagePRO-II, you will need the following equipment:
When connecting to an ImagePRO-II, use high-quality shielded cables.
If you intend to operate the ImagePRO-II remotely using the Web Interface, you can do so
over a wireless network. For this option, you will need a wireless router and access to a
wireless network, along with a device such as a smartphone, computer or laptop, notebook
or tablet.
fåëí~ääáåÖ=íÜÉ=fã~ÖÉmolJff
Use the following procedure to install the ImagePRO-II:
1.
Follow the unpacking procedures as listed in the
Unpacking and Inspection
section on page 16.
2.
As required, refer to
the
Physical and Electrical Specifications
section on
page 135 in Appendix A for electrical and mechanical details.
3.
As required, refer to the
ImagePRO-II Rear Panel
section on page 12 in
Chapter 2 for the locations of all connectors.
4.
If you are rack mounting the ImagePRO-II chassis, follow the rack mount
procedures as outlined in the
Rack-Mount Installation
section on page 16.
5. Ethernet
Connections
a.
Connect an Ethernet cable to a Switch.
b.
Ensure that the Switch is connected to a data port.
c.
Connect the Ethernet Switch to the ImagePRO-II’s Ethernet port.
6. Source
Connections
Table 3-2.
Equipment List, Basic ImagePRO-II System
Qty.
Item
Note
1
ImagePRO-II unit
1
Display device
Customer supplied
1
Ethernet Switch
Customer supplied (Optional: for web interface, Encore Controller, or
ScreenPRO-II Controller)
1
Ethernet cable
Customer supplied
1
Video cable
Customer supplied (Optional, for Genlock and Genlock Loop)
TBD
Dedicated sources
Analog and/or digital video as required (customer supplied)
Note
As an alternate method, you can use a direct Ethernet
connection or a wireless connection between the
ImagePRO-II and a web-enabled device.
Summary of Contents for ImagePRO-II
