Barco ImagePRO-II, User Manual

Page: 56 / 196

42 ImagePRO-II • User’s Guide
4. Menu Orientation
Configuring Inputs
If the
Sample Phase
is
n/a
, then either
1:1 Sample
is
Off
, or the input is not
analog YP
b
P
r
or RGB.
•
H Total
— This value is the total pixel count per line. This value cannot be
adjusted on the DVI-I or SDI connectors (Inputs
1
and
5
).
•
H Position
— Sets the offset of the start of the active area from H Sync.
•
H Active
— Sets the size of the active area.
•
V Total
— Displays the total line count per frame. This value cannot be changed
for any input.
•
V Position
— Sets the offset of the start of the active area from V Sync.
•
V Active
— Sets the size of the active area.
When
1:1 Sample
is
Off
, the
Timing Adjust Submenu
changes to the
Edge Timing
Adjust Submenu
. For more information, refer to the
Adjusting Edge Timings
section on
this page.
^ÇàìëíáåÖ=bÇÖÉ=qáãáåÖë
When the
1:1 Sample
option is
Off
, the
Edge Timing Adjust Submenu
is available in
place of the
Timing Adjust Submenu
.
Figure 4-12.
Edge Timing Adjust Submenu (sample)
Using this menu, you can set the exact locations of the active video edges, when
1:1
Sample
is
Off
. For the right and left edges, the values are in pixels, and the position is
relative to the start of H Sync. For the top and bottom edges, the values are in numbers of
lines, relative to the start of V Sync.
Because
1:1 Sample
is off, the image is oversampled, and the image quality may be lower
than when
1:1 Sample
is turned on.
pÉííáåÖ=fåéìí=`çåíê~ëí=~åÇ=_êáÖÜíåÉëë
From the
Input Menu
, select
Contrast
to change the contrast of the selected input. Select
Brightness
to change the brightness.
For both
Contrast
and
Brightness
, the adjustment range is in percentages, from
25%
to
150%
. The default setting for both parameters is
100%
. Use the
ADJUST
knob to scroll
through the range, and press
SEL
to select a value.
EDGE TIMING ADJUST
> Right Edge
2460
Left Edge 592
Top Edge 85
Bottom Edge 803
Note
When making active area adjustments, turn on the
Output
Raster Box
, and align the input image with all four edges of
the box. To turn on the raster box, refer to the
Working with
Test Patterns
section on page 63.