ImagePRO-II • User’s Guide
171
`K==réÖê~ÇáåÖ=cáêãï~êÉ
Upgrading Firmware Using the Web Interface
^ìíçã~íáÅ~ääó=réÖê~ÇáåÖ=cáêãï~êÉ=rëáåÖ=íÜÉ=tÉÄ=
fåíÉêÑ~ÅÉ
Use the following procedure to automatically upgrade ImagePRO-II software with the
Web Interface:
1.
Open a compatible web browser, and enter the ImagePRO-II’s IP address in the
address bar. The web page shown in the following illustration appears.
Figure C-5.
System Information Tab
This page provides information about the current firmware version. In addition,
there are two options:
~
Auto Upgrade
~
Upload Firmware
2.
To detect and upload new firmware automatically, click
Auto Upgrade
.
If a new firmware version is available, it loads and a confirmation message
appears. This process may take several seconds.
pÉäÉÅíáåÖ=~=cáêãï~êÉ=cáäÉ=íç=réäç~Ç=ïáíÜ=íÜÉ=tÉÄ=fåíÉêÑ~ÅÉ
Use the following procedure to select a firmware version to install using the Web
Interface:
1.
On the
System Information
tab, click
Upload Firmware
.
The
System Firmware Upgrade
window appears.
2.
Click
Choose File
.
3.
On the window that appears, navigate to and select the firmware file you want to
upload.
4.
On the
System Firmware Upgrade
window, click
Submit
.
Summary of Contents for ImagePRO-II
