Barco ImagePRO-II, User Manual

Page: 115 / 196

ImagePRO-II • User’s Guide 101
5. Web Remote Control Operations
Obtaining System Information with the Web Interface
^ÅÅÉëëáåÖ=íÜÉ=tÉÄ=fåíÉêÑ~ÅÉ

To access the Web Interface, you can connect an ImagePRO-II directly to a computer
or mobile device, using a wireless network or a cable, or use an optional Ethernet
Switch as described in the following procedure.
1.
On the ImagePRO-II’s rear panel, ensure that the Ethernet port is connected to an
Ethernet Switch, and the Switch
is connected to a data port.
2.
Connect the Switch to the computer or mobile device from which you want to run
the ImagePRO-II.
3.
Connect inputs and outputs to the ImagePRO-II. For details, refer to the
Installation
section of Chapter 3,
Hardware Installation
, on page 19.
4.
Power up the ImagePRO-II.
5.
Power up the input source and output display devices.
6.
Turn on the ImagePRO-II’s
DHCP
setting:
~ On the
Setup Menu
, select
System
>
Ethernet
.
~ Select
DHCP
and turn it
On
.
7.
On the computer or mobile device, open a browser and type the ImagePRO-II’s IP
address in the following format:
nnn.nnn.nnn.nnn
The
Folsom ImagePRO-II
page appears on the display device(s), with the
System Information
tab available.
lÄí~áåáåÖ=póëíÉã=fåÑçêã~íáçå=ïáíÜ=íÜÉ=tÉÄ=fåíÉêÑ~ÅÉ
The
System Information
tab, shown in the following illustration, is the first page you see
when you access the ImagePRO-II from the web.
Figure 5-1.
System Information Tab
Firmware Version
Available Upgrade
Upgrade to Latest Version
Upload Another Version
FPGA Temperature