Barco ImagePRO-II, User Manual

Page: 69 / 196

ImagePRO-II • User’s Guide 55
4. Menu Orientation
Configuring Outputs
^ÇàìëíáåÖ=lìíéìí=qáãáåÖ
From the
Output Menu
, select
Timing Adjust
to display the
Output Timing Adjust
Submenu
. On this submenu, shown in the following illustration, you can change the
selected output’s total, active and sync settings, and reposition video on the output.
Figure 4-31.
Output Timing Adjust Submenu (sample)
Your settings:
• Do not result in cropping the image
• Do not change the image aspect ratio
• Must be within the range of timings supported by the output display, to avoid loss
of signal
• Update the output Area of Interest
On this menu:
•
H Total
— Adjusts (in pixels) the total pixel count per line for the selected output.
•
H Position
— Adjusts (in pixels) the offset of the start of the output active area
from H sync.
•
H Active
— Adjusts (in pixels) the horizontal size of the output active area.
•
H Sync
— Adjusts (in pixels) the H sync width.
•
V Total
— Adjusts (in lines) the total line count per frame.
•
V Position
— Adjusts (in lines) the offset of the start of the output active area from
V sync.
•
V Active
— Adjusts (in lines) the vertical size of the output active area.
•
V Sync
— Adjusts (in lines) the V sync width.
rëáåÖ=`çãéLpJsáÇÉç=^Çàìëí
By selecting
Comp/S-Vid Adjust
from the
Output Menu,
you can adjust the output
encoder, which produces composite and S-Video outputs. The following illustration shows
the
Comp/S-Vid Adjust Submenu
.
Note
All but the most advanced users are advised to avoid
changing the output timing values.
OUTPUT TIMING ADJUST
> H Total
2200
H Position 192
H Active 1920
H Sync 88
V Total 1125
V Position 41
V Active 1080
V Sync 5