Barco ImagePRO-II, User Manual

Page: 99 / 196

ImagePRO-II • User’s Guide 85
4. Menu Orientation
Using the System Menu

To set a static IP address for the ImagePRO-II, use the following procedure:
1.
Ensure that the
DHCP
setting is
Off
.
2.
From your network administrator, obtain a valid IP address, including subnet and
gateway.
3.
On the
Ethernet Submenu
, select
Set Static IP
.
4.
On the
Set IP Submenu
, select
SUB
(net). The last character in the first field
becomes available, as indicated by the empty field and an underscore.
You must change the
SUB
parameter before editing either of the other
parameters.
5.
Turn the
ADJUST
knob to change the first value. As you continue turning the
knob, you can change all three values in this field. Values range from
000
to
255
in all four fields.
6.
Press
SEL
to accept your change in the first field. The last character in the next
field becomes available.
7.
Continue until you have created the subnet value you want. Press
SEL
.
8.
Make similar changes in the
GW
and
IP
fields.
9.
Press
SEL
to accept your final change.
^ÅÅÉëëáåÖ=íÜÉ=fã~ÖÉmolJff=oÉãçíÉäó

After you have set up the Ethernet options as described in
Querying the DHCP
Server
and
Setting a Static IP Address
on page 84, use the following procedure to
set up the ImagePRO-II:
1.
On a PC, laptop, or mobile device with the Microsoft Windows OS, open a
command prompt window.
2.
Type the IP address and port on the prompt, using the following format:
> telnet xxx.xxx.xxx.xxx 10001
where the x’s represent the ImagePRO-II IP address, and 10001 is the port.
After Ethernet communication is established, the telnet window functions in the
same fashion as a serial COM port communication.
3.
Verify with the network administrator that the ImagePRO-II can communicate with
the computer.
Note
If you press
ESC
at any time before accepting your final
change, all your edits will be removed, and the original values
restored.