50
ImagePRO-II • User’s Guide
4. Menu Orientation
Configuring Outputs
lìíéìí=jÉåì=cìåÅíáçåë=~åÇ=pìÄãÉåìë
All
Output Menu
functions and submenus are discussed in the following sections:
Setting the Output Format
Setting ColorSpace, Sample Rate, and Bit Depth
Using EDID Auto Config
Setting Output Effects
Setting the Area of Interest
About Genlock Settings
Adjusting Output Timing
Saving an Output Configuration
Using Comp/S-Video Adjust
Restoring Output Configuration Default Values
Setting Output Sync
pÉííáåÖ=íÜÉ=lìíéìí=cçêã~í
The
Output
Format
is the first setting on the
Output Menu.
This option sets the resolution
and frame rate at which you drive your projector or display. When you change the output
format, you also change the following settings:
•
Output colorspace, based on the format you select
•
Sync settings, based on the format you select
•
Genlock and H/V offsets, which reset to
0
•
The default
Area of Interest
, which resets to match the output’s active area. For
more information, refer to the section
Setting the Area of Interest
on page 52.
To change the output format, use the following procedure:
1.
On the
Output Menu
, scroll to the format field and press
SEL
.
2.
Scroll to the format you want using the
ADJUST
knob, then press
SEL
again. The
output is not updated until you press
SEL
.
To minimize synchronization problems, select a frame rate that is consistent with
your input sources.
Example
: If you are using 59.94 NTSC video inputs, running the output at
the same rate reduces frame-rate conversion artifacts.
rëáåÖ=bafa=^ìíç=`çåÑáÖ
Extended Display Identification Data
(
EDID
) is a data structure that an output display
uses to describe itself to a video source. The EDID can include information such as the
manufacturer’s name, a serial number, product type, timings supported by the display,
display size, and other data.
For devices connected to the ImagePRO-II, you can read the name of the digital display
and the preferred video format that the display uses.
The
Output Auto Config
Submenu
supports
letting the output device on the DVI-D,
HD-15, HDMI, or DisplayPort connector change the output format of the
ImagePRO-II
.
As
the format changes, the colorspace, sample rate and bit depth may also change. For
details, refer to
Setting ColorSpace, Sample Rate, and Bit Depth
on page 57.
The following figure illustrates the
EDID Auto Config Submenu
.
Summary of Contents for ImagePRO-II
