Aria Aria-100, Programming Manual, Page: 97 / 163

Programming Manual for Digital Key Telephone System GDK-162/100/34e
Admin Programming
99A Software 1/6/00
A-92
BTN ITEM DEFAULT RANGE REMARK
1 MSG Wait
Reminder Tone
Timer
00 00 -60
(2 Digits)
Determines the amount of time between repeated reminder
tones to a key telephone with a message waiting.
2 Hook Switch
Flash Timer
05 01-25
(2 Digits)
This timer determines how long the user could depress the
hook switch in order for it to be considered as a FLASH
(Timed-Break Recall). (For SLT)
3 Hook Switch
Bounce Timer
01 01-25
(2 Digits)
This timer determines the length of timer that is needed to
regard as a valid on-hook or off-hook. (For SLT)
4 DID/DISA No
Answer Timer
20 00 -99
(2 Digits)
A DID call will be forwarded to attendant if the station is busy
or does not answer within this time.
5 ICM Box Timer 30 00 -60
(2 Digits)
Determines the amount of time programmed stations will ring
when ICM box user presses the [CALL] button.
6 Door Open
Timer
20 05 -99
(2 Digits)
This timer determines of the length of time that is needed to
activate as a door open relay using external page relay.
7 Call FWD No
Answer Timer
015 000 -600
(3 Digits)
The call forward busy/no answer feature will take place using
this timer. If this timer has a non-zero value and an extension
is set at busy, no answer forward by station user then the
extension will ring for this timer and take place a forward to
the next.
8 Dial Tone Timer 10 01-20
(2 Digits)
If action is not taken within ICM dial tone timer, user will hear
error-tone.
9 Inter Digit Timer 05 01-20
(2 Digits)
The time between digits cannot exceed Inter-digit timer, or
error tone is received.
10 Automatic
Release Timer.
030 000 -300
(3 Digits)
Uncompleted CO call will be automatically released after this
timer.
11 Paging Timeout
Timer
015 000 -255
(3 Digits)
Determines the maximum time of a page. The system will
automatically disconnect the page at the end of this time
unless the caller has hung up earlier.
12 Ring Stop
Detection Timer
060 010 -150
(3 Digits)
This timer is to secure time interval between incoming ringing
signals so that the active ringing can be lasted in the system
until this timer is expired.
13 Wink Timer 010 010 -200
(3 Digits)
The time duration of Seize Acknowledge Signal to DID line.
14 Minimum Hook
Flash Timer
020 000 -250
(3 Digits)
The minimum bound time that system considers as hook
flash for SLT . 005
15 SMDR Timer 000 000 -250
(3 Digits)
When the SMDR is enabled, the call to be printed is set by
this SMDR timer. The calls exceeding this time limit are
printed.
16 DVU User
Record Timer
020 010 - 255
(3 Digits)
The time duration of DVU user greeting (Outgoing/Incoming
messages)
17 CO Digit
Analysis
Counter
3 0 - 9
(1 Digit)
When digits are dialed as many as this counter and 3SEC is
expired, the CO TX-path is connected.