Programming Manual for Digital Key Telephone System
GDK-162/100/34e
Admin Programming
99A Software 1/6/00
A-27
2. PRE-PROGRAMMED DATABASE
This section describes the pre-programming of the data.
When installed,At installation, the installer
user
must program
some databasePGM 00 items
(
ex.
Nationality, Normal/Extend) first,
otherwise system may not operate properly. If you want to change station numbers or feature
codes, then use PGM 01. To change Slot Assignment, proceed PGM 02. The system is
initialized when installed, but to re-initialize the database with default values provided by
system, proceed PGM 00.
PROCEDURE FOR PRE-PROGRAMMING
(1) Set Nationality and Normal/Extend Mode appropriately. (System reset and re-initializes
automatically. See Section 2.1)
(2) Set Slot Assignments (If configuration is not equal to default Slot Assignments, change slot
assignments, and change the status of DIP switch 8 on MPB to ON. Reset system manually. See
Section 2.3)
(3)
Set Numbering Plan. (See Section 2.2)
2.1 DATABASE INITIALIZATION & NATION ASSIGNMENT (PGM 00)
The system has been pre-programmed with certain features which are called default data (Table 1.5.1
- 1.5.9). These features are loaded into memory when the system is initialized. The system should be
always initialized when installed or at any time the database has been corrupted. To initialize the
system to default values, proceed as follows;
PROCEDURE
INITIALIZATION
PRESS FLEX KEY (1-10)
(1)
[TRANS/PGM]
+ 00.
(2) Press one of buttons (1-10) as described at Table 2.1.1. Initially
all LEDs are off and the selected Flex.
Button‟s LED will be
steady on.
(3) To initialize database press BTN 1-8 and the
[HOLD/SAVE]
button, then database is initialized with default data and system
goes to step (1).