Programming Manual for Digital Key Telephone System
GDK-162/100/34e
Admin Programming
99A Software 1/6/00
A-96
5.9 STATION GROUP ATTRIBUTE (PGM 48)
When assigning a station group to any type of hunt group, the system initializes hunt attributes by
default value for it's own function. It can be programmed to meet each customer's individual need.
PROCEDURE
HUNT GROUP ATTRIBUTE
ENTER GROUP # (xxx-xxx)
(1)
[TRANS/PGM]
+ 48.
(2) Enter Hunt Group Number. The station group to be
programmed it's attributes should be assigned to any type of
hunt group at PGM 47. If you enter the station number not
assigned to hunt group, you will hear error tone.
CIRCULAR 620
PRESS FLEX KEY (1-7)
To program, use the Flex. Buttons as Table 5.9.1. (Ex. Group
620 is
Circular hunt
)
①
To program timers, after pressing the one of BTN 1-4, enter
the timer value within data range matching digit number.
②
To program overflow destination, press BTN 5 and do one of:
Enter station number,
Enter Hunt group number,
Press the
[SPEED]
button for deleting.
⑤③
To program announce location, press BTN 6 and do one of:
Dial '1' and enter station number,
Dial '2' for assigning to DVU,
Press the
[SPEED]
button for deleting.
⑥④
To assign this circular hunt group to pilot hunt, press BTN 7
and dial 1 (Yes).
TERMINAL 620
PRESS FLEX KEY (1-7)
To program, use the BTN as Table 5.9.1. (Ex. Group 620 is
Terminal hunt
). Program methods are same as above step.
Formatted: Bullets and Numbering
Formatted: Bullets and Numbering