Programming Manual for Digital Key Telephone System
GDK-162/100/34e
Admin Programming
99A Software 1/6/00
A-75
7
Line Drop
using CPT
YES/NO
NO (OFF)
If this field set to Yes, CPT checks the incoming CO line
when answered and if CPT detects dial tone, then
system drops the line for toll restriction.
8
Night DVU
YES/NO
NO (OFF)
If this field set to Yes, an outside caller only receives
DVU message (in system annc. 2) and then the line is
dropped at night mode.
TABLE 4.2.1 Button Configuration for CO Attribute
– II (PGM 31)
4.3 CO LINE RING ASSIGNMENT (PGM 32)
The telephones can be assigned to signal incoming CO ringing during day and night mode operation.
If assigned to ring, the designated stations will ring (CO line ringing) when the assigned CO line rings
into the system.
All incoming CO rings signal to the 1
st
attendant station (station # 101: port 1) during
day and night mode by default and the other stations are not assigned any ring both day and night
mode.
PROCEDURE
CO LINE RING
ENTER CO RANGE
(1)
[TRANS/PGM]
+ 32.
01-05 ASSIGN RING
PRESS FLEX KEY 1-2
(2) Enter CO line range (Ex. 01-05).
(3) To program, use the BTN 1-2. User can assign CO line ring to
Station (BTN 1) or Pilot Group/Station (BTN 2).
01-05 ASSIGN RING
ENTER STA RANGE
To assign CO line ring to station, press BTN 1. Enter the station
range. (Ex. 100-110)
01-05 ASSIGN RING
100-110 U0:U0:U0
Dial 2 digits to assign ringing status and delay ring counter for
the first station in range. (See Table 4.3.1)
01-05 ASSIGN RING
ENTER HUNT GRP# / STA#
To assign CO line ring to station member of hunt group, press
BTN 2.
Note
:
Selected station group for CO Ring Assignment should be
assigned as hunt group at PGM 47 already.
01-05 ASSIGN RING
ENTER HUNT GRP# / STA#
To assign CO line ring to Hunt group or pilot number, press
Flex. Button 2.
Note
:
Selected station group for CO Ring Assignment should be
assigned as hunt group at PGM 47 already.