Analog Devices SHARC ADSP-214 Series, Hardware Reference Manual, Page: 844 / 1192

ADSP-2146x External Port Registers
A-18 ADSP-214xx SHARC Processor Hardware Reference
Running Reset Control Register (RUNRSTCTL)
The
RUNRSTCTL
register is used to control the running reset functionality
and is described in Table A-7 .
ADSP-2146x External Port Registers
The registers in the following sections are specific to the ADSP-2146x
external port and include the external port, the DDR2 controller, and
AMI registers.
External Port Control Register (EPCTL)
The following registers are used to control asynchronous memory inter-
face (AMI), the DDR2 and SDRAM controllers, and the shared memory
interface. The external port control register can be programmed to arbi-
trate the accesses between the processor core and DMA, and between
different DMA channels. These registers are shown in
Figure A-6 and
described in Table A-8 .
Table A-7. Running Reset Control Register Bit Descriptions (RW)
Bit Name Description
0 PM_RUNRST_PINEN Configures the RESETOUT pin for RUNRST
input.
0 =
RESETOUT
pin is
RESETOUT
1 =
RESETOUT
pin is RUNRST input
1 PM_RUNRST_EN Enable the Running Reset Functionality. If this
bit is cleared, attempting to cause a running reset
by toggling the
RUNRSTIN
pin has no affect
0 = Running reset disabled
1 = Running reset enabled
31–2 Reserved
www.BDTIC.com/ADI