Ziton ZP3, Руководство по установке и обслуживанию

Страница: 109 / 163

Chapter 5: System configuration
ZP3 Fire Control Panel Installation, Commissioning, and Maintenance Manual 101
× Ò ¾
· ß ¥ µ » â
Á § ·
¶ ® ¥ ° µ
× Ò ¾
· ß ¥ µ » â
Á § ·
¶ ® ¥ ° µ
× Ò ¾
· ß ¥ µ » â
Á § ·
¶ ® ¥ ° µ
× Ò ¾
· ß ¥ µ » â
Á § ·
¶ ® ¥ ° µ
45 104-111 69 296-303 93 478-495 117 680-687
46 112-119 70 304-311 94 496-503 118 688-695
47 120-127 71 312-319 95 504-511 119 696-703
48 128-135 72 320-327 96 512-519 120 704-711
49 136-143 73 328-335 97 520-527 121 712-719
50 144-151 74 336-343 98 528-535 122 720-727
51 152-159 75 344-351 99 536-543 123 728-735
52 160-167 76 352-359 100 544-551 124 736-743
53 168-175 77 360-367 101 552-559 125 744-751
54 176-183 78 368-375 102 560-567 126 752-759
55 184-191 79 376-383 103 568-575 127 760-767
The setup requirements to conform to EN 54 are provided below. All paragraph
numbers refer to EN 54 part 2 of 1997 unless otherwise specified.
1. Para 7.1.4 and 8.1.3: AVF shall be switched off for all points.
2. Para 7.3.1: Under menu Setup > System Configuration > Zone LED Link,
zone LEDs shall be linked to the appropriate zones.
3. In menu Setup > System Configuration > Control Key Switch Level:
Para 7.4.1: The Accept key shall be set up to level 1 or 2
Para 7.6.1: The Reset key shall be set up to level 2
Para 7.8(a): The Silence Alarms key shall be set up to level 2
Para 7.8(b): The Sound Alarms key shall be set up to access level 2
4. Para 7.8: If accessory board ZP3AB-MA8 outputs are required to serve the
function of “output to fire alarm devices (item C)” then they must be defined
as sounder outputs when mapping. Standard outputs and use of non-
monitored output boards shall not be used to comply with EN 54 item C
requirements.
5. Para 7.10: If accessory board ZP3AB-MA8 outputs are required to serve the
function of “control to fire protection equipment” then they must be defined as
control outputs when mapping. The programming must not include delays to
output when the output is used to serve the function of “control to fire
protection equipment”. Standard outputs and use of non-monitored