Ziton ZP3, Руководство по установке и обслуживанию

Страница: 89 / 163

Chapter 4: Software programming
ZP3 Fire Control Panel Installation, Commissioning, and Maintenance Manual 81
The Global Settings > Editing menu provides the ability to simultaneously
programme a set of attributes for a group of point addresses as follows.
The menu path is: Points > Global Settings > Editing.
After programming globally with this menu, individual devices that need different
attributes can be changed using the Points menu. Scroll through the point
addresses. The editing options available for each address are described in
Table 22.
Ê ³ Õ ´ © É É ¬ ¾ ® ¥ ° µ ³ º º ¨ © · · © · © º ¥ µ ® ¶ µ ¥ ® ° ·
Ç ¶ µ ¥ ® ° × © · » ¨ ¥ ¶ µ ¥ ® °
Sensor sensitivity High, medium, standard, low
Fire AVF (Alarm Verification Function) Enabled or disabled
Fault AVF (Alarm Verification Function) Enabled or disabled (Note: Global only)
Sounder base Present or not
Detector self-test Enabled or disabled
Selecting the Accept Points menu instructs the panel to carry out a self-learning
process, to accept all current devices attached to the Z-loops, or peripheral
boards, as the current system configuration. The panel displays the message
“Accepting points” and counts down toward zero. On completion, the panel
displays “Calibrating”. If a device was not accepted, it is shown as “unaccepted”.
The menu path is: Setup > Points > Accept Points.
The Sounders menu provides the tools for setting up system sounders. Loop
devices and panel outputs that operate sounders must be defined as such to the
panel to ensure that they behave correctly.
The menu path is: Setup > Sounders or Setup > Pnts > INDN. The available
sounder setup options are described in Table 23.
Ê ³ Õ ´ © É ¿ ¬ à ® § ° º © ¨ · © µ § ¶ ® ¶ µ ¥ ® ° ·
Ç ¶ µ ¥ ® ° × © · » ¨ ¥ ¶ µ ¥ ® °
View SAB View which Z-loop sensors have been defined as having a sounder
base (SAB). The point address of the first sensor is displayed, plus the
total number of sounder bases. Scroll to view the list.
Edit SAB Define which sensors have a sounder base. Add or delete a point
address.
View Mapped
Sounders View of all outputs (Z-loop and panel outputs), which have been defined
as sounders in the I/O mapping tables. Scroll to view the list.