Ziton ZP3, Руководство по установке и обслуживанию

Страница: 95 / 163

Chapter 4: Software programming
ZP3 Fire Control Panel Installation, Commissioning, and Maintenance Manual 87
connection. After being loaded into the panel, minor modifications can be made
to the programming, directly via the panel menus. In this case, it is possible to
load the programming from the panel back to the PC, for saving to disk, and
printed report and record keeping.
The menu path is: Setup > Planner. Menu options available are as follows (see
Table 31).
Ê ³ Õ ´ © ¿ Ó ¬ ¾ ´ ³ ° ° © ¨ · © µ § ¶ ® ¶ µ ¥ ® ° ·
Ç ¶ µ ¥ ® ° × © · » ¨ ¥ ¶ µ ¥ ® °
Send Map This function is used to send the programmed data that exists in a ZP3
panel to an external PC.
Receive Map This function is used to receive programmed data from a PC.
The preferred baud rate settings when using Planner to configure a ZP3
panel are shown in Table 32 below.
Ê ³ Õ ´ © ¿ É ¬ ¾ ¨ © ± © ¨ ¨ © º ¾ ´ ³ ° ° © ¨ Õ ³ § º ¨ ³ µ © · © µ µ ¥ ° ¦ ·
Baud rate Data bits Parity Stop bits
Receive 38400 8 Even 1
Send 9600 8 Even 1
Alternatively you can set Z-Port 1 to “ZCP3” to allow control directly from
Planner.
These are high level operations for use by a senior administrator of the fire
system, to alter options or settings that cannot be changed by installation,
maintenance, or operation personnel.
The menu path is: Setup > Level 4 Operations. The following options are
available (see Table 33).