Ziton ZP3, Руководство по установке и обслуживанию

Страница: 93 / 163

Chapter 4: Software programming
ZP3 Fire Control Panel Installation, Commissioning, and Maintenance Manual 85
Ç ¶ µ ¥ ® ° × © · » ¨ ¥ ¶ µ ¥ ® °
Peer Define Defines the properties of all network panels, e.g. number of loops,
zones, and communication ports.
The Relays menu allows for the setup of the standard built-in relays.
The menu path is: Setup > System Configuration > Relays. The following options
are available (see Table 28).
Ê ³ Õ ´ © É Ä ¬ à Å · µ © ¯ » ® ° ± ¥ ¦ § ¨ ³ µ ¥ ® ° ¨ © ´ ³ Å · © µ § ¶ ® ¶ µ ¥ ® ° ·
Ç ¶ µ ¥ ® ° × © · » ¨ ¥ ¶ µ ¥ ® °
Fire Relay The common fire relay can be set to normally de-energised (open
contact, closing on alarm) or normally energised (closed contact, open
on alarm). The latter state is described as “inverted” in the menu.
Fault Relay The common fault relay can be set to normally energised (open contact,
closing on alarm) or normally de-energised (closed contact, open on
alarm). The latter state is described as “inverted” in the menu.
RMC Alarm The remote manned centre output is connected to RMC-routing
equipment. It should be set to restore only after a reset.
Sounder Relays The sounder outputs (four outputs, controlled from two addresses) can
be set to operate as common, from any alarm, or as programmable. If
they are set to programmable, then they must be linked to activating
inputs in the I/O-menu.
The Printer menu allows for the setup of the optional in-panel printer.
The menu path is: Setup > System Configuration > Printer. The following options
are available (see Table 29).
Ê ³ Õ ´ © É È ¬ à Å · µ © ¯ » ® ° ± ¥ ¦ § ¨ ³ µ ¥ ® ° ¶ ¨ ¥ ° µ © ¨ · © µ § ¶ ® ¶ µ ¥ ® ° ·
Ç ¶ µ ¥ ® ° × © · » ¨ ¥ ¶ µ ¥ ® °
Printer Type Allows the type of printer to be defined. Current types are:
1. NONE = no printer attached
2. Able-24/25 = panel printer
3. Able-24+IN) = panel printer
4. Serial desktop = external printer, 80 column
Printer Options Defines the information to be printed, categories are:
1. Fire Alarm
2. Fault
3. Panel Operation
4. O/P Activation