Ziton ZP3, Руководство по установке и обслуживанию

Страница: 5 / 163

ZP3 Fire Control Panel Installation, Commissioning, and Maintenance Manual iii
This manual is intended for use by the personnel who install and commission the
ZP3 Fire Control Panel, and has been prepared in accordance with ZP3
operating software version 3.12.
Advisory messages alert you to conditions or practices that can cause unwanted
results. The advisory messages used in this document are shown and described
below.
Warning messages advise you of hazards that could result in injury
or loss of life. They tell you which actions to take or to avoid in order to prevent
the injury or loss of life.
Caution messages advise you of possible equipment damage. They tell
you which actions to take or to avoid in order to prevent the damage.
Note messages advise you of the possible loss of time or effort. They
describe how to avoid the loss. Notes are also used to point out important
information that you should read.
Trained service personnel must carry out procedures in this manual.
The ZP3 panel is powered from a 230 VAC primary supply and from a 24 VDC
battery backup supply.
The power supply forms part of the main board assembly. This
assembly consists of a circuit board (incorporating the power supply), mounted
on a metal chassis, with the power supply covered by a metal enclosure. The
enclosure must not be opened, and non-authorized persons must never remove
the circuit board from the chassis. Very high voltage potentials exist on the circuit
board, and disassembling any part of the power supply could be dangerous to
field personnel.
Connection to the 230 VAC primary supply (+10%,
í
15%), must comply with
National wiring regulations. The wiring must be permanently connected to the
building wiring through a 10 A, 3-core cable, and a double pole 10 A isolation
switch.