Graphical Digital Panel Meter WPMZ-3 INSTRUCTION MANUAL
82
IM-0883-01
StartCondition
Select condition of start measuring.
Normal:
Start measuring immediately after receiving instruction.
Threshold:
Start measuring after excess or less than the threshold after receiving instruction.
*This threshold is not comparison waveform (Green lines).
Operation:[MENU]
⇒
[Input]
⇒
[WaveCompareA/B]
⇒
[StartCondition]
Setting: Normal (Initial state), Threshold
Threshold
Set threshold level if the [StartCondition] is “Threshold”.
*This setting is enable when the [StartCondition] is “Threshold”
Operation:[MENU]
⇒
[Input]
⇒
[WaveCompareA/B]
⇒
[Threshold]
Setting value:
±99999 (Initial state is 10000)
ThresholdOnDir
Set threshold on direction if the [StartCondition] is “Threshold”.
*This setting is enable when the [StartCondition] is “Threshold”
Excess:
Start measuring after deisplay value excess the threshold after receiving instruction.
LessThan:
Start measuring after deisplay value less than the threshold after receiving instruction.
Operation:[MENU]
⇒
[Input]
⇒
[WaveCompareA/B]
⇒
[ThresholdOnDir]
Setting:
Excess (Initial state), LessThan
ThresholdTimeout
Alarm and finish measurement if the [StartCondition] is “Threshold” and start condition is not satisfied for a
certain time.
*This setting is enable when the [StartCondition] is “Threshold”
Operation:[MENU]
⇒
[Input]
⇒
[WaveCompareA/B]
⇒
[ThresholdTimeout]
Setting value:
0.00
～
99.99 [sec] (Initial state is 0.00)
*This function is disable if setting value is 0.00[sec].
StartPosition
Set delay for up to start measurement after satisfying start condition if the [StartCondition] is “Threshold”.
*This setting is enable when the [StartCondition] is “Threshold”
Operation:[MENU]
⇒
[Input]
⇒
[WaveCompareA/B]
⇒
[StartPosition]
Setting value:
-100 to +1000 points (Initial state is 0)
*If setting value is less than 0, wave data contains data before satisfying start condition.
*Delay time is different by [SamplingRate].
example) [SamplingRate]:100times/sec, [StartPosition]:200 points
Delay time = (1/100) × 200 = 2[sec]
(Start drawing graph after satisfied start condition and draw 1500 points.)
