Toshiba TOSVERT VF-S15 series, Инструкция по эксплуатации

Страница: 357 / 394

E6582175
M-5
[Trip information]
Error code Failure code Name Description Remedies

0034 Over torque boost
fault 
The automatic torque boost parameter
 setting is too high.

The motor has too small impedance.

Set a lower automatic torque boost
parameter  setting.

Make an auto-tuning.

0035 CPU fault 2 
The control CPU is defective.

Contact your Toshiba distributor.

0037 Optional unit fault 2 
An optional device is defective.

Contact your Toshiba distributor.

003A CPU fault 3 
The control CPU detected a fault.

Reset the inverter. The cause can be
surrounding noise. If the problem is not
solved, contact your Toshiba distributor.

0063 Heavy cycle of main
power ON/OFF 
Main power ON/OFF during running is
repeated frequently.

Initial failure if it is caused by other
reasons.

Reduce the frequency of repetition of
main power ON/OFF during running.

Contact your Toshiba distributor.

0040 PTC fault 
PTC thermal protection is occurred.

Check the PTC in motor.

0045 Servo lock fault 
The motor shaft is not locked in servo lock
operation.

Reduce the load in servo lock operation.

0047 Auto-tuning error
(PM motor) 
When auto-tuning (relating parameters
are
pt
=
6
,
f400
=
2
), the current of
the permanent magnet motor exceeded
the threshold level.

The inductance of permanent magnet
motor is too small.

Auto tuning for permanent magnet motor
is not allowed for this motor, please
measure inductance with the LCR meter
etc.


The motor is not connected.

Set V/F control mode selection
pt
=
0
,
for operation check without connecting
motor.
* This marking trips can be selected valid or invalid by parameters.