Thermo Scientific 146i, Инструкция по эксплуатации

Страница: 318 / 340

C-Link Protocol Commands
Communications Configuration
B-40 Model 146 i Instruction Manual Thermo Fisher Scientific
set addr ip address
This command sets the analyzer’s IP address , where address consists of four
numbers ranging from 0-255 inclusive, separated by “.”.
Send: set addr ip 192.168.1.200
Receive: set addr ip 192.168.1.200 ok
addr nm
This command reports the IP netmask.
Send: addr nm
Receive: addr nm 255.255.255.0
set addr nm address
This command sets the nm address , where address consists of four numbers
ranging from 0-255 inclusive, separated by “.”.
Send: set addr nm 255.255.255.0
Receive: set addr nm 255.255.255.0 ok
baud
This command reports the current baud rate for the serial port
(RS232/RS485). The example below reports that the current baud rate is
9600 baud.
Send: baud
Receive: baud 9600
set baud rate
rate = | 1200 | 2400 | 4800 | 9600 | 19200 | 38400 | 57600 | 115200 |
This command sets the instrument baud rate. The example below sets the
instrument’s baud rate to 9600.
Note After the command is sent, the baud rate of the sending device must
be changed to agree with the instrument.
▲
Send: set baud 9600
Receive: set baud 9600 ok
dhcp
This command reports the current state of use of DHCP on or off. DHCP
is used to assign an IP address to the analyzer automatically. The example
below shows that DHCP is on.
Send: dhcp
Receive: dhcp on