Thermo Scientific 146i, Инструкция по эксплуатации

Страница: 301 / 340

C-Link Protocol Commands
Calibration
Thermo Fisher Scientific Model 146 i Instruction Manual B-23
set stream time value
This command enables value , where value is to attach or disable time stamp
to streaming data string, according to Table B–5 . The example below
attaches a time stamp to streaming data.
Send: set stream time 0
Receive: set stream time 0 ok
Table B–5. Stream Time Values
Value Stream Time
00 Attaches time stamp to streaming data string
01 Disables time stamp to streaming data string
set cal o3 bkg
This command will auto-calibrate the O
3
background. The example below
shows a successful auto-calibration of the O
3
background. This command is
only available if the photometer option is installed.
Send: set cal o3 bkg
Receive: set cal o3 bkg ok
set cal o3 coef
This command will auto-calibrate O
3
coefficients based on O
3
span gas
concentrations. If the mode is incorrect, the instrument responds with
“can’t, wrong settings”. The example below shows a successful auto-
calibration of the O
3
coefficient. This command is only available if the
photometer option is installed.
Send: set cal o3 coef
Receive: set cal o3 coef ok
lamp
This command reports the current photometer lamp setting in percent.
The example below shows that the lamp setting is 10.0%. This command is
only available if the photometer option is installed.
Send: lamp
Receive: lamp 10.0 %
set lamp value
This command sets the photometer lamp setting to value , where value is a
floating point number representing a percentage of the photometer lamp
setting. The example below sets the photometer lamp to 10.0%. This
command is only available if the photometer option is installed.
Calibration