Thermo Scientific 146i, Инструкция по эксплуатации

Страница: 323 / 340

C-Link Protocol Commands
I/O Configuration
Thermo Fisher Scientific Model 146 i Instruction Manual B-45
This command assigns digital input channel (1-16) to activate the action
indicated by index (1-35), when the input transitions to the designated state
(high or low). Use “list din var” command to obtain the list of supported
index values and corresponding actions.
Send: set din 5 9 high
Receive: set din 1 9 high ok
dout channel
This command reports the index number and output variable and the
active state assigned to output
channel . The example below reports the
input 2 to be assigned an index number 2 corresponding to “local/remote”
with the active state being open.
Send: dout 2
Receive: dout 2 2 LOCAL/REMOTE open
set dout channel index state
This command assigns digital output channel to be assigned to the action
associated with index , and assigns it an active state of state (open or closed).
Send: set dout 2 2 open
Receive: set dout 2 2 open ok
dtoa channel
This reports the outputs of the 6 or 12 Digital to Analog converters,
according to
Table B–13 . The example below shows that the D/A #1 is
97.7% full-scale.
Send: dtoa 1
Receive: dtoa 1 97.7%
Note All channel ranges are user definable. If any customization has been
made to the analog output configuration, the default selections may not
apply.
▲
Table B–13. Default Output Assignment
D to A Function Single Range Dual Range Auto Range
1 Voltage Output O
3
Not Used Not Used
2 Voltage Output O
3
Not Used Not Used
3 Voltage Output Not Used Not Used Not Used
4 Voltage Output Not Used Not Used Not Used
5 Voltage Output Not Used Not Used Not Used
6 Voltage Output Not Used Not Used Not Used