5 - 27
5. DISPLAY AND OPERATION SECTIONS
5.10.3 Positioning operation
POINT
Software(MR Configurator2
TM
) is required to perform positioning operation.
Turn ON the forced stop (EM1) when performing positioning operation.
During the positioning operation, the "UP" and the "DOWN" buttons are invalid.
When using this function, external input signal operation will be disabled. When
controlling from a PLC or upper level device, the power must be turned off and
then on.
With no command given from the external command device, positioning operation can be executed once.
Click "Test Mode" on the menu bar and click "Positioning Mode" on the menu.
Click " Positioning Mode " on the menu bar and click "Move Distance Unit Selectiom" on the menu.
Check Command pulse unit (Electronic gear valid) and click OK.
Electronic gear ratio that is set in the PA05 / PA06 / PA07 is enabled.
Clicking displays the confirmation window for switching to the test operation mode.
Click the "OK" button to display the setting screen of the Positioning operation.