Raritan PX3TS, Руководство пользователя

Страница: 439 / 842

Chapter 6: Using the Web Interface
415

To upgrade an existing USB-cascading chain from a firmware
version older than 3.3.10, you must start from the last slave device
and so on until the master device. See
Upgrade Sequence in an
Existing Cascading Chain
(on page 415).
Upgrade Sequence in an Existing Cascading Chain
Depending on the firmware version(s) of your cascading chain, there may
or may not be limitations for the firmware upgrade sequence in the
chain.
Upgrade from "pre-3.3.10" to 3.3.10 or post-3.3.10:
You must follow the firmware upgrade sequence below to upgrade a
cascading chain from a firmware version older than 3.3.10 to version
3.3.10 or later. If you do not follow this upgrade sequence, you will
not be able to access some cascaded devices over the Internet.

The upgrade must start from the last slave device (S), then the
second to last, the third to last, and so on until the master device
(M).
Red numbers below represent the appropriate upgrade sequence.
'N' is the final one to upgrade.

You must upgrade ALL devices in the chain to 3.3.10 or later. If
you upgrade only some devices in the chain, networking issues
occur on some cascaded devices.
Upgrade from 3.3.10 or post-3.3.10 to post-3.3.10:
There is no upgrade sequence limitation.
Firmware version 3.3.10 is compatible with later firmware versions
so you can upgrade all devices of the chain in a random order.
Important: Raritan does not guarantee that no upgrade sequence
limitation will be required for all future firmware versions. It is
highly suggested to check the latest revision of the Cascading Guide
or your product's User Guide/Online Help before performing the
firmware upgrade. The other alternative is to always stick to the
same sequence as the above diagram.