Raritan PX3TS, Руководство пользователя

Страница: 51 / 842

Chapter 3: Initial Installation and Configuration
27
DB9 pin signal DB9 pin No. RJ-45 pin No. RJ-45 pin signal
RxD 2 3 TxD
GND 5 4 GND
GND 5 5 GND
TxD 3 6 RxD
DTR 4 7 DSR
RTS 7 8 CTS
DCD 1 (Not connected)
RI 9 (Not connected)
N/A
Note: The blue Cisco RJ-45 to DB9 adapter cable CANNOT be used for
connecting a modem. See
RJ45-to-DB9 Cable Requirements for
Modem Connections (for iX7
™
Only)
(on page 756).
Bulk Configuration Methods
If you have to set up multiple PX3TS devices, you can use one of the
following configuration methods to save your time.
Use a bulk configuration file:

Requirement: All PX3TS devices to configure are of the same model
and firmware.

Procedure: First finish configuring one PX3TS. Then save the bulk
configuration file from it and copy this file to all of the other PX3TS
devices.
See
Bulk Configuration
(on page 418).
Use a TFTP server:

Requirement: DHCP is enabled in your network and a TFTP server is
available.

Procedure: Prepare special configuration files, which must include
fwupdate.cfg, and copy them to the root directory of the TFTP server.
Re-boot all PX3TS after connecting them to the network.
See Bulk Configuration or Firmware Upgrade via DHCP/TFTP (on
page 679).