Raritan PX3TS, Руководство пользователя

Страница: 392 / 842

Chapter 6: Using the Web Interface
368
3. In the Syslog Server field, specify the IP address to which the syslog
is forwarded.
4. In the Transport Protocol field, select one of the syslog protocols:
TCP, UDP or TCP+TLS. The default is UDP.
Transport
protocols Next steps
UDP

In the UDP Port field, type an appropriate port number. Default is 514.

Select the "Legacy BSD Syslog Protocol" checkbox if applicable.
TCP NO TLS certificate is required. Type an appropriate port number in the TCP Port field.
TCP+TLS
A TLS certificate is required. Do the following:
a. Type an appropriate port number in the "TCP Port" field. Default is 6514.
b. In the CA Certificate field, click to select a TLS certificate. After
importing the certificate, you may:

Click Show to view its contents.

Click Remove to delete it if it is inappropriate.
c. Determine whether to select the "Allow expired and not yet valid certificates" checkbox.

To always send the event message to the specified syslog server as long as a TLS
certificate is available, select this checkbox.

To prevent the event message from being sent to the specified syslog server when
any TLS certificate in the selected certificate chain is outdated or not valid yet,
deselect this checkbox.
Note: If the required certificate file is a chain of certificates, and you are
not sure about the requirements of a certificate chain, see
TLS
Certificate Chain (on page 783).