Raritan PX3TS, Руководство пользователя

Страница: 417 / 842

Chapter 6: Using the Web Interface
393
5. Select the System SNMP Notification Action.
Note: If you have not configured the System SNMP Notification Action to
specify the SNMP destination(s), see
Editing or Deleting a Rule/Action
(on page 379).
Front Panel Settings
You can set up the default mode of the front panel display, and front
panel functions for outlet switching or actuator control.
Note that available front panel settings are model dependent.

Outlet switching -- available on outlet-switching capable models
only.

Actuator control -- available on all PX3TS-iX7 series, but NOT
available on PX3TS series. This is because only PX3TS-iX7 product
models have the dot-matrix panel for this operation.

Default front panel mode setup -- available on all PX3TS-iX7 series,
but NOT available on PX3TS series.
To configure the front panel settings:
1. Choose Device Settings > Front Panel.
2. Configure the following:

To configure the default view of the LCD display, select one mode
below.
Note: The default view is shown in the automatic mode. See
Automatic and Manual Modes
(on page 113).
Mode Data entered
Automatic mode The LCD display cycles through both the
transfer switch/inlet and overcurrent
protector information. This is the default.
Overcurrent protector information is
available only when you PX3TS has
overcurrent protectors.
Inlet overview The LCD display cycles through the
transfer switch/inlet information only.

To enable the front panel outlet-switching function, select the
"Outlet switching" checkbox.

To enable the front panel actuator-control function, select the
"Peripheral actuator control" checkbox.