Raritan PX3TS, Руководство пользователя

Страница: 540 / 842

Chapter 8: Using the Command Line Interface
516
Interface Description
eth1
(PX3TS-iX7)
Determine the IPv4 preferred host name of the
ETH1 interface (that is, wired networking).
eth2
(PX3TS-iX7)
Determine the IPv4 preferred host name of the
ETH2 interface (that is, wired networking).
wireless Determine the IPv4 preferred host name of the
WIRELESS interface (that is, wireless
networking).
bridge Determine the IPv4 preferred host name of the
BRIDGE interface (that is, bridging mode).

<name> is a host name which:

Consists of alphanumeric characters and/or hyphens

Cannot begin or end with a hyphen

Cannot contain more than 63 characters

Cannot contain punctuation marks, spaces, and other symbols
Setting the IPv4 Address
After selecting the static IP configuration mode, you can use this
command to assign a permanent IP address to the PX3TS device.
config:# network ipv4 interface <ETH> address <ip address>
Variables:

<ETH> is one of the network interfaces: ethernet, wireless, or bridge.
Note that you must choose/configure the bridge interface if your
PX3TS is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE
interface function. The IP parameters of the ETHERNET and
WIRELESS interfaces do NOT function.
Interface Description
ethernet
(PX3TS) Determine the IPv4 address of the ETHERNET
interface (that is, wired networking).
eth1
(PX3TS-iX7)
Determine the IPv4 address of the ETH1 interface
(that is, wired networking).
eth2
(PX3TS-iX7)
Determine the IPv4 address of the ETH2 interface
(that is, wired networking).