Raritan PX3TS, Руководство пользователя

Страница: 486 / 842

Chapter 8: Using the Command Line Interface
462
About the Interface
The PX3TS provides a command line interface that enables data center
administrators to perform some basic management tasks.
Using this interface, you can do the following:

Reset the PX3TS device

Display the PX3TS and network information, such as the device name,
firmware version, IP address, and so on

Configure the PX3TS and network settings

Troubleshoot network problems
You can access the interface over a local connection using a terminal
emulation program such as HyperTerminal, or via a Telnet or SSH client
such as PuTTY.
Note: Telnet access is disabled by default because it communicates
openly and is thus insecure. To enable Telnet, see
Changing Telnet
Settings
(on page 298).
Logging in to CLI
Logging in via HyperTerminal over a local connection is a little different
than logging in using SSH or Telnet.
If a security login agreement has been enabled, you must accept the
agreement in order to complete the login. Users are authenticated first
and the security banner is checked afterwards.
With HyperTerminal
You can use any terminal emulation programs for local access to the
command line interface.
This section illustrates HyperTerminal, which is part of Windows
operating systems prior to Windows Vista.
To log in using HyperTerminal:
1. Connect your computer to the PX3TS via a local (USB or RS-232)
connection.
2. Launch HyperTerminal on your computer and open a console
window. When the window first opens, it is blank.
Make sure the COM port settings use this configuration:

Bits per second = 115200 (115.2Kbps)

Data bits = 8

Stop bits = 1