Oracle X7-8, Руководство по обслуживанию

Страница: 237 / 308

Returning the Server to Operation
After replacing components inside of the server, perform the procedures in the following
sections.
This section describes how to return the server to service after performing cold service.
Description Link
Steps for returning the server to operation
after cold service.
“Prepare the Server for Operation” on page 237
Steps for server power-on options. “Power On the Server” on page 238
Prepare the Server for Operation
Use this procedure to return the server to an operational state after performing cold service.
1. Remove Antistatic Measures.
■
1. Remove any antistatic straps or conductors from the server chassis.
2. Remove the antistatic wrist strap from yourself.
2. Ensure that all external front and back components are fully installed.
3. Ensure that all cables are connected to the back of the server.
4. Connect all AC power cables to their inlets on the back of the server and verify
that they are locked.
The retaining clips lock the power cables and prevent accidental disconnect.
To ensure redundancy, power for the server should come from at least four separate circuits.
5. If necessary, connect the other end of the AC power cables to the supply outlet.
6.
Ensure that the server is powering into standby power mode.
Returning the Server to Operation 237