11.6.25 Error 24: Encoder channel 3, initialization error
11.6.25.1 Error 24-1 (emergency code 7307h)
Cause: Channel 3 Initialization: error, module identification failed
Suggested steps:
Please look up, if there's placed the right hardware module in the slot of X8
Identification of the X8
module
l
This is probably a hardware problem of the X8
module!
l
Please check if the correct X8 module is
installed.
l
In any case look at init outputs in the message
window of the
Moog D
RIVE
A
DMINISTRATOR
5 .
l
If the error occurs again (after 24V reset),
please contact your service provider.
MOOG
ID No.: CB40859-001 Date: 11/2020
MSD Servo Drive - Device Help
390
11 Alarms & warnings
11.6.25.2 Error 24-2 (emergency code 7307h)
Cause: Channel 3 Initialization: common error from encoder option module
Suggested steps:
Please look at Log entry window for error code information
Initialization encoder
channel 3
l
Error during the initialization routines of
encoder channel 3.
l
In any case look at init outputs in the message
window of the
Moog D
RIVE
A
DMINISTRATOR
5 .
l
The most common cause of error is the wiring
to the encoder.
11.6.25.3 Error 24-3 (emergency code 7307h)
Cause: Channel 3 Initialization, SSI: error, encoder monitoring
Suggested steps:
Please connect the encoder correctly.
Initialization encoder
channel 3
l
Error during the initialization routines of
encoder channel 3.
l
In any case look at init outputs in the message
window of the
Moog D
RIVE
A
DMINISTRATOR
5 .
l
The most common cause of error is the wiring
to the encoder.