Miranda Kaleido-X, Руководство пользователя, Страница: 187 / 407

Managing Layouts
179
To avoid pixel cropping on spanned monitors, you must position room displays so that there is no gap
between them. Use XEdit’s
Remove horizontal space and/or Remove vertical space buttons to make
sure your displays are perfectly positioned for spanning.
You must also ensure that each display has the same pixel-per-inch (or -per-mm) ratio, calculated as
horizontal resolution (pixels) divided by display width (inches or mm) and vertical resolution divided by
display height. Ideally, you should use displays that have the same physical size and resolution.
The figure below shows two displays properly sized and positioned for monitor spanning:
Notes
• Monitors can extend outside the edge of a display, but not completely.
• The use of a mouse is not completely supported with spanned video monitors.
• In the case of a KMV-3901/3911 multi-viewer, which supports a maximum of eight video
monitors over two displays, a spanned video monitor counts as two (i.e. if you have one
spanned video monitor, you can only add six other video monitors to your layout; if you span
two video monitors, you can add only four other video monitors.
Warning icon appears even if monitor
is one pixel over the edge
Video monitor spanned over two displays
with warning icon in top right corner
Horizontal: 800 pixels ÷ 400 mm = 2 pixels/mm
Vertical: 600 pixels ÷ 300 mm = 2 pixels/mm
Horizontal: 1366 pixels ÷ 683 mm = 2 pixels/mm
Vertical: 768 pixels ÷ 384 mm = 2 pixels/mm